Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect force motor angle sensor harness connector.
3. Check resistance between force motor angle sensor connector terminals.

   Force motor angle sensor		Condition	Resistance
   Terminal
   3	7	0 deg. C (32 deg. F)	Approx. 34.8 KOhm
   		25 deg. C (77 deg. F)	Approx. 10.0 KOhm
   		40 deg. C (140 deg. F)	Approx. 5.2 KOhm

4. Check continuity between force motor angle sensor connector and ground.

   Force motor angle sensor	--	Continuity
   Terminal
   3	Ground	Not existed
   7

Is the inspection result normal?

YES

INSPECTION END

NO

Force motor temperature sensor is malfunction. Replace steering column assembly. Refer to STEERING COLUMN : Removal & Installation .