Work Procedure
- SAVING VEHICLE SPECIFICATION (BCM)
CONSULT
Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification.
Refer to Work Procedure .
NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.GO TO 2.
- SAVING VEHICLE SPECIFICATION (CAN GATEWAY)
Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification.
Refer to Work Procedure .
NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.GO TO 3.
- SAVING VEHICLE SPECIFICATION (TPMS)
Perform "Before Replace ECU" of "Read / Write Configuration" to save or print current vehicle specification.
Refer to Work Procedure (Before Replacement) 3CH CAN GATEWAY or Work Procedure (Before Replacement) 6CH CAN GATEWAY.
NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing BCM.GO TO 4.
- REPLACE BCM
Replace BCM. Refer to Removal and Installation .
GO TO 5.
- WRITING VEHICLE SPECIFICATION (BCM)
Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
GO TO 6.
- REGISTER INTELLIGENT KEYS
For initialization and registration of Intelligent Keys, refer to CONSULT Immobilizer mode and follow the on-screen instructions.
GO TO 7.
- WRITING VEHICLE SPECIFICATION (TPMS)
Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure (After Replacement) .
GO TO 8.
- WRITING VEHICLE SPECIFICATION (CAN GATEWAY)
Perform "After Replace ECU" of "Read / Write Configuration" or "Manual Configuration" to write vehicle specification. Refer to Work Procedure .
GO TO 9.
- INITIALIZE TPMS
Perform TPMS initialization. Refer to Work Procedure .
Work End.