Component Inspection

Do you have CONSULT '

Do you have CONSULT '

YES>>

GO TO 2.

NO>>

GO TO 3.

With CONSULT

1. Turn ignition switch ON.
2. On CONSULT screen, select "ENGINE" >> "Active test" >> "WASTEGATE ACTUATOR".
3. Select the following monitor items:
   • W/G ACTUATOR POSITION B1
   • W/G ACTUATOR POSITION B2
   • W/G ACTUATOR POSI SEN B1
   • W/G ACTUATOR POSI SEN B2
4. Perform the test.
5. Check that the relationship of the values displayed on the monitor items as the following.

   Monitor item	W/G ACTUATOR POSITION B1/B2 (m)	W/G ACTUATOR POSI SEN B1/B2 (V)
   Value	0.0073 - 0.0087	3.61 - 4.11
   	0.0033 - 0.0047	2.25 - 2.75

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace turbocharger assembly (do not replace electric wastegate control actuator only). Refer to TURBOCHARGER : Exploded View .

Without CONSULT

1. Turn ignition switch OFF.
2. Disconnect wastegate control actuator harness connector.
3. While checking the POSITION SENSOR OUT voltage with an oscilloscope, apply a voltage of 12 V to the positive or negative terminal.

Does ACTUATOR SHAFT visually operate and POSITION SENSOR OUT voltage change?

YES>>

INSPECTION END

NO>>

Replace turbocharger assembly (do not replace electric wastegate control actuator only). Refer to TURBOCHARGER : Exploded View .