LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 1994 >> Rodeo LS, RWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Bleeding Brake System >> Bleeding Procedures >> Manual Bleeding
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Manual Bleeding

  1. Clean master cylinder cap and surrounding area, then remove cap. Fill master cylinder. Start engine and run it at idle. Install clear vinyl bleed hose onto first bleed screw to be serviced. See BRAKE LINE BLEEDING SEQUENCE table. Place other end of hose in clean transparent container.
  2. Partially fill container with clean brake fluid so end of hose is submerged in fluid. Open bleed screw 1-2 turns. Slowly depress brake pedal through its full travel.
    CAUTION: DO NOT release brake pedal until bleed screw has been tightened.
  3. Close bleed screw, and release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until flow of brake fluid is clear and bubble free. Proceed to next bleed screw.
NOTE: Check fluid level in master cylinder frequently during bleeding sequence.
scientia non olet · About LEMON Manuals