Cruise Control Module
WARNING: This page is about a different car, the 1996 Isuzu Trooper. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect cruise control module connector. Perform all circuit tests at cruise control module wiring harness connector. SeeFig 1 . Ensure ignition switch and cruise control main switch are on. Unless told otherwise, check circuit between specified terminal and ground. See CRUISE CONTROL MODULE table.
CRUISE CONTROL MODULE
| Terminal No. (Circuit)(1) | Test Condition | Specification | ||
|---|---|---|---|---|
| 1 (Transmission Control Module) | Ignition & Main Switch On | Continuity | ||
| 3 (Cruise Indicator Light) | Ignition Switch On | 0 Volts | ||
| 4 (Clutch Sw. - M/T) | Neutral/Not In Neutral | 0 Volts/12 Volts | ||
| 4 (Mode Switch - A/T) | P, R & N/D, 3, 2 & L | 0 Volts/12 Volts | ||
| 5 (Vent Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||
| 6 (Ground) | n/a | Continuity To Ground | ||
| 7 (Vacuum Pump) | See CRUISE CONTROL ACTUATOR Test | 2 Amps Maximum | ||
| 9 (Resume Switch) | Resume Switch On | Continuity | ||
| 10 (Set Switch) | Set Switch On | Continuity | ||
| 12 (Starter) | Ignition Sw. In Start Position | 12 Volts | ||
| 14 (Safety Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||
| 15 (Main Switch) | Ignition & Main Switch On | 12 Volts | ||
| 16 (Brake Switch) | Switch Depressed/Released | No Continuity/ Continuity | ||
| 19 (Vehicle Speed Sensor) | n/a | 13,500 Ohms To Infinite Resistance | ||
| 20 (Brake Switch) | Switch Released/Depressed | 0 Volts/12 Volts | ||
|
||||