Oxygen Sensor (O2S)
WARNING: This page is about a different car, the 1996 Acura SLX. However, it is still accessible from the selected car via links, so may be relevant.
- Start engine and warm to operating temperature. Disconnect oxygen sensor. Connect DVOM between Purple wire of oxygen sensor and ground. Place DVOM on 2-volt scale.
- Using another DVOM on 20-volt scale, connect DVOM in series between Purple wire from PCM and positive post of battery. This will simulate a rich condition, causing PCM to respond by leaning mixture. Reading on DVOM connected to oxygen sensor should decrease to less than .3 volt.
- Move DVOM lead from positive battery post to negative battery post. This will simulate a lean condition, causing PCM to respond by richening mixture. Reading on DVOM connected to oxygen sensor should increase to greater than .8 volt. If reading does not change as specified, replace oxygen sensor.
- If a second DVOM is not available, connect a jumper in Purple wire from PCM. Hold jumper in one hand and touch positive post of battery with other hand to simulate a rich condition. Touch negative post of battery to simulate a lean condition. For additional testing procedures, see TESTS W/CODES article.