Cruise Control Module
WARNING: This page is about a different car, the 1995 Isuzu Trooper. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect cruise control module connector. Perform all circuit tests at cruise control module wiring harness connector. SeeFig 1 . Ensure ignition switch and cruise control main switch are on. Unless told otherwise, check circuit between specified terminal and ground. See CRUISE CONTROL MODULE table.
CRUISE CONTROL MODULE
| Terminal No. (Circuit)(1) | Test Condition | Specification | ||||
|---|---|---|---|---|---|---|
| 1 (Cruise Indicator Light) | Ignition & Main Switch On | 12 Volts | ||||
| 3 (Vent Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||||
| 4 (Neutral Sw. - M/T) | Neutral/Not In Neutral | 0 Volts/12 Volts | ||||
| 4 (Mode Switch - A/T) | P, R & N/D, 3, 2 & 1 | 0 Volts/12 Volts | ||||
| 5 (Battery +) | Ignition & Main Switch On | 12 Volts | ||||
| 6 (Set Switch) | Set & Main Switch On | 12 Volts | ||||
| 7 (Safety Valve) | See CRUISE CONTROL ACTUATOR Test | 62-72 Ohms | ||||
| 8 (Brake Switch) | Switch Depressed/Released | 0 Volts/12 Volts | ||||
| 9 (Ground) | n/a | Continuity To Ground | ||||
| 10 (Vacuum Pump) | See CRUISE CONTROL ACTUATOR Test | 2 Amps Maximum | ||||
| 11 (Resume Switch) | Resume & Main Switch On | 12 Volts | ||||
| 12 (Brake Switch) | Switch Released/Depressed | 0 Volts/12 Volts - | ||||
| 13 (Vehicle Speed Sensor)(2) | n/a | 13,500 Ohms To Infinite Resistance | ||||
|
||||||