Cruise Control Module

WARNING: This page is about a different car, the 1997 Honda Passport. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect cruise control module connector. Perform all circuit tests at cruise control module wiring harness connector. See Fig 1 . Ensure ignition and cruise control main switch are on. Unless told otherwise, check circuit between specified terminal and ground. See appropriate table:

CRUISE CONTROL MODULE HARNESS CONNECTOR TERMINAL

Fig 1: Identifying Cruise Control Module Wiring Harness Connector Terminals

Courtesy of ISUZU MOTOR CO.

CRUISE CONTROL MODULE HARNESS CONNECTOR TERMINAL ⁽¹⁾

Between

Circuit

Test Condition

Specification

3 & Ground

Cruise Indicator Light

Ignition & Main Switch On

12 Volts

4 & Ground

Clutch Switch (M/T)

Pedal Released

0 Volts

4 & Ground

Clutch Switch (M/T)

Clutch Depressed

12 Volts

4 & Ground

Mode Switch (A/T)

P R & N

0 Volts

4 & Ground

Mode Switch (A/T)

D 3 2 & 1

12 Volts

5 & Ground

Vent Valve

See CRUISE CONTROL ACTUATOR Test

62-72 Ohms

6 & Ground

Ground

Continuity To Ground

7 & Ground

Vacuum Pump

See CRUISE CONTROL ACTUATOR Test

2 Amps Maximum

9 & Ground

Resume Switch

Resume & Main Switch On

12 Volts

10 & Ground

Set Switch

Set & Main Switch On

12 Volts

14 & Ground

Safety Valve

See CRUISE CONTROL ACTUATOR Test

62-72 Ohms

15 & Ground

Battery +

Ignition & Main Switch On

12 Volts

16 & Ground

Brakelight Switch

Pedal Depressed

0 Volts

16 & Ground

Brakelight Switch

Pedal Released

12 Volts

19 & Ground

Vehicle Speed Sensor

⁽²⁾ Voltage

20 & Ground

Brakelight Switch

Pedal Released/ Depressed

0 Volts/12 Volts

⁽¹⁾	Connector terminals not listed are not used. Unless told otherwise, check circuit between terminal specified and ground.

⁽²⁾	Test condition or specification not available. See VEHICLE SPEED SENSOR testing for additional information.