Specifications Index
OASIS SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | NA | ||
| Rear | NA | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BLEEDING PROCEDURES | ||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drum Brakes | |||
| Service Specifications | DRUM BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE TESTING | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | NA | ||
| Belt Routing | NA | ||
| Engine Cooling | |||
| General Service Specifications | NA | ||
| Radiator Cap Pressure | NA | ||
| Thermostat R & I | NA | ||
| Water Pump R & I | REMOVAL & INSTALLATION | ||
| Engine Mechanical | |||
| Compression | Standard ; 242 psi (17 kg/cm2
) Maximum variation between cylinders is 28 psi (2.0 kg/cm2 ) Minimum ; 135 psi (9.5 kg/cm2 ) at 250RPM |
||
| Oil Pressure | With engine temperature at 176°F (80°C), ensure oil pressure is 10 psi (0.7 kg/cm2
) at idle. With engine temperature at 176°F (80°C), ensure oil pressure is 50 psi (3.5 kg/cm2 ) 3000 at RPM. |
||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate (AT) | |||
| Drive Plate (AT) | 74 N.m (55 ft-lb) | ||
| Flywheel Bolts | 103 N.m (76 ft-lb) | ||
| Fuel System | |||
| Pressure Specification | 42-55 psi (2.9-3.9 kg/cm2 ) at 800 RPM | ||
| Fuel Pressure Test Procedure | PRESSURE TESTING | ||
| Fuel Filter Location | REMOVAL & INSTALLATION (OASIS, ODYSSEY & PRELUDE) | ||
| Fuel Filter R & I | REMOVAL & INSTALLATION (OASIS, ODYSSEY & PRELUDE) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plug | |||
| Type | NGK; ZFR5F-11 Nippondenso; KJ16CR-L11 |
||
| Gap | 0.039 - 0.043in. (1.0-1.1 mm) | ||
| Torque | 13 Nm | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 80 ft. lbs. (108 N.m) | ||