Programming New Id Code
NOTE:
This procedure erases all registered ID codes and registers a new ID code.
- Make sure that all doors are closed and unlocked. Open driver's side door. In starter key into ignition. Then go to next step.
- Turn ignition switch to ACC position and return it to OFF quickly three times. (Must be carried out within five seconds after step 1 is finished) Is action complete? If Yes, then go to next step. If No, then go to step 1 .
- Close and open driver side door quickly two times. (Must be carried out within 10 second after step 2 is finished). Is action complete? If Yes, then go to next step. If No, then go back to step 1 .
- Turn ignition switch to ACC position and return to OFF position quickly five times. Close and open driver's side door quickly 1 time. (Must be carried out within 10 seconds after step 3 is finished). Is action complete? If Yes, then go to next step. If No, then go back to step 1 .
- Control units locks and unlocks the doors one time. Does control unit work normally? If Yes, then go to next step. If No, then go back to step 1 .
- Operate lock or unlock button of transmitter. (Must be carried out within 20 seconds after step 5 is finished). Is action complete? If Yes, then go to next step. If No, then go back to 1 .
- Control unit locks and unlocks the doors one time. Does control unit work normally? If Yes, then go to next step. If No, then go back to step 1 .
- Operate lock or unlock button of the transmitter. (Must be carried out within 20 seconds after step 7 is finished). Is action complete? If Yes, then go to next step. If No, then go back to step 1 .
- If registration succeeds, control unit locks and unlocks the doors one time. If registration fails, control unit locks and unlocks the doors three times then go back to step 1 .