LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2002 >> Rodeo LS, 2.2 D >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft, Power Door Lock & Keyless Entry Systems >> Programming >> Programming New Id Code
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Programming New Id Code

NOTE: This procedure erases all current ID codes and replaces them with a new ID code.
  1. Ensure all doors are closed and unlocked. Open driver's door. Insert key into ignition. Go to next step.
  2. Turn ignition switch to ACC position, then to OFF position 3 times within 5 seconds after completing step  1 . Go to next step.
  3. Close driver's door and open it 2 times within 10 seconds after completing step  2 . Go to next step.
  4. Turn ignition switch to ACC position, then to OFF position 5 times. Close driver's door and open it. This step must be completed within 10 seconds after step  3 . Control unit should lock and unlock doors one time. If doors lock and unlock one time, go to next step. If doors did not lock and unlock one time, repeat step  1 .
  5. Depress LOCK or UNLOCK button of transmitter within 20 seconds after step  4 . Control unit should lock and unlock doors one time. If doors lock and unlock one time, go to next step. If doors did not lock and unlock one time, repeat step  1 .
  6. Depress LOCK or UNLOCK button of transmitter within 20 seconds after step  5 . Control unit will compare temporary ID code with receiving ID code. If codes are the same, control unit will lock and unlock doors one time. If it does, programming is complete. If codes are not the same, control unit will lock and unlock doors 3 times. Repeat step  1 and attempt to reprogram ID code again.
scientia non olet · About LEMON Manuals