Installation (4X2 Model)

Install power steering unit to crossmember.
Tighten fixing bolt to specified torque.

Torque: 116 N.m (85 lb ft)
Connect the feed line and return line.
Torque: 25 N.m (18lb ft)
Install tie-rod end assembly to knuckle.
Torque: 118 N.m (87 lb ft)
1. Align the setting marks made at removal. Install the universal joint assembly to the transfer gear assembly.
  Temporary tighten the universal joint bolt.
2. Install the universal joint assembly to the power steering unit assembly.
  Temporary tighten the universal joint bolt.
3. Install the transfer gear assembly with the shim to frame.
  Torque: 54 N.m (40 lb ft)
4. Tighten the universal joint bolt to the specified torque.
  Torque: 31 N.m (23 lb ft)
Install the stone guard.
Bleed the system. Refer to BLEEDING THE POWER STEERING SYSTEM .