Brake Switch (Cruise Control): Service and Repair

Brake Switch (W/ Cruise Control)

Removal

1. Disconnect the battery ground cable.




2. Disconnect the connector (1), loosen the lock nut (3) and then remove the brake switch (2) by turning it.

Installation

To install, follow the removal steps in the reverse order, noting the following points.
1. Check to see if the brake pedal has been returned by the return spring to the specified position.
2. Turn the switch clockwise until the tip of the threaded portion of the brake switch contacts the pedal arm.




3. Turn the switch counterclockwise until the space between the tip of the threaded portion and the pedal arm is 0.5 to 1.0 mm (0.02 - 0.04 in.).