Installation (4x4 Model)

Install power steering unit to crossmember.
Tighten fixing bolt to specified torque.

Torque: 116 N.m (85 lb ft)
Install power steering unit with crossmember to frame by aligning the setting marks made when removing.
Tighten crossmember mounting bolt to specified torque.

Torque: 173 N.m (128 lb ft)
Install lower control arm bolt. Refer to SUSPENSION FRONT .
Install torsion bar. Refer to SUSPENSION FRONT .
Connect the feed line and return line.
Torque: 25 N.m (18 lb ft)
Install tie-rod end assembly to knuckle.
Torque: 118 N.m (87 lb ft)
1. Align the setting marks made at removal.
2. Install the universal joint assembly to the transfer gear assembly.
  Temporary tighten the universal joint bolt.
3. Install the universal joint assembly to the power steering unit assembly.
  Temporary tighten the universal joint bolt.
4. Install the transfer gear assembly to frame.
  Torque: 54 N.m (40 lb ft)
5. Tighten the universal joint bolt to the specified torque.
  Torque: 31 N.m (23 lb ft)
Install the stone guard.
Bleed the system. Refer to BLEEDING THE POWER STEERING .