Section 12 (Engine Controls - System & Component Testing): Introduction

WARNING: This page is about a different car, the 2003 Isuzu Rodeo Sport, 2003 Isuzu Rodeo, and 2003 Isuzu Axiom. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For circuit identification, see WIRING DIAGRAMS and PIN VOLTAGE CHARTS .

Before testing separate components or systems, follow proper workflow. See DIAGNOSTIC PROCEDURE under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article. If no Diagnostic Trouble Codes (DTC) are present and a no-start condition exists, proceed to BASIC DIAGNOSTIC PROCEDURES article. If no DTCs are present and a driveability condition exists, proceed to TROUBLE SHOOTING - NO CODES article for diagnosis by symptom (i.e., ROUGH IDLE, ENGINE STALLS, etc.).

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens. Testing procedures not covered in this article require a scan tool. For scan tool testing, see appropriate SELF-DIAGNOSTICS article.