LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2006 >> i-350 >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Keyless Entry System And Remote Functions) >> Diagnostic Information and Procedures >> Keyless Entry System Inoperative >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Isuzu i-370, 2007 Isuzu i-290, 2007 GMC Canyon, and 2007 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the transmitter being used is a correct P/N transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Using the J 43241  , place the keyless entry transmitter on the test pad and press each transmitter button one at a time. The green light on the tester should illuminate and a tone should sound with each button press.
    • If no tone or illumination occurs with any of the buttons, replace the transmitter battery and retest the transmitter.
    • If no tone or illumination occurs with one or more, but not all, buttons, replace the transmitter.
  3. Ignition ON, verify the scan tool No. of Fob's Programmed parameter is Fob 1, Fob 2, Fob 3, or Fob 4.
    • If not the specified value, reprogram the keyless entry transmitters. Refer to Transmitter Programming . If the keyless entry transmitters will not program, replace the BCM.
  4. If all circuits test normal, replace the BCM.
scientia non olet · About LEMON Manuals