LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2007 >> Ascender 4WD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System & Fuel System - 4.2L - DTC P0442 To DTC P2101 >> DTC P0446 >> Circuit/System Testing >> FTP Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

FTP Sensor

  1. Ignition ON and fuel cap removed, verify that the FTP sensor parameter is between 1.3-1.7 volts.
    • If the FTP sensor parameter is not within the specified range, test the FTP low reference circuit for an open or high resistance. If the circuit tests normal, replace the FTP sensor.
  2. With the GE-41415-50  , connect the J 41413-200  to the fuel filler neck. See Special Tools .
  3. Start the engine.
  4. Allow the engine to idle.
  5. Use the Purge/Seal function to seal the system with a scan tool.
  6. Command the EVAP canister purge solenoid valve to 20 percent.
  7. Observe the vacuum/pressure gage on the J 41413-200  and the FTP parameter on the scan tool. See Special Tools .
  8. Verify that the vacuum increases to the abort limit on the scan tool or more than 3.2 volts and the value is closely similar between the scan tool and the vacuum/pressure gage on the J 41413-200  . See Special Tools .
    • If the values are not similar or the voltage is not within the specified range, replace the FTP sensor.
scientia non olet · About LEMON Manuals