LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 4.2L - DTC P0013 To DTC P0134 >> DTC P0116 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Disconnect the ECT sensor.
  2. Turn ON the ignition, with the engine OFF.
  3. Measure for the proper range of 4.9-5.2 volts between the ECT sensor signal circuit and a good ground with a DMM.
    • If the voltage is less than 4.9 volts, test the ECT sensor signal circuit for a high resistance short to ground.
    • If the ECT sensor signal circuit tests normal and the voltage is still not within the proper range, then replace the PCM.
  4. Remove and test the ECT sensor. Refer to Component Testing .
    • If the resistance measurements of the ECT sensor are out of range, replace the sensor.
    • If the ECT sensor tests normal and the DTC continues to set, then replace the PCM.
scientia non olet · About LEMON Manuals