LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Isuzu >> 2007 >> Ascender RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Remote Functions) >> Diagnostic Information and Procedures >> Keyless Entry System Inoperative >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Saab 9-7X. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the transmitter is the correct transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Verify the scan tool Fob Battery parameter for the appropriate keyless entry transmitter is OK.
    • If no the specified value, replace the transmitter battery.
  3. Verify the scan tool Fob Programmed parameter for the appropriate keyless entry transmitter is Yes.
  4. Place the transmitter on the test pad of the J 43241  and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
    • If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter.
  5. Operate the transmitter while observing the scan tool Last Fob Button Pressed parameter. The parameter should correspond with the function selected on the transmitter.
    • If the parameter does not match the function selected on the transmitter, replace the transmitter.
  6. If all circuits test normal, replace the LGM.
scientia non olet · About LEMON Manuals