Transmission Control Module (TCM) and Main Control Valve Body - In-Vehicle Procedures: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of JAGUAR CARS, INC.

Install the new seals.

Courtesy of JAGUAR CARS, INC.
Install the new seals.

Courtesy of JAGUAR CARS, INC.
Install the TCM and main control valve body sealing block.

Courtesy of JAGUAR CARS, INC.

CAUTION: Make sure the TCM and main control valve body are protected against electrostatic discharge. Failure to follow this instruction may result in component damage.

Align the transmission selector shaft to the TCM and main control valve body.

Courtesy of JAGUAR CARS, INC.
Install the TCM and main control valve body retaining bolts.
- Tighten to 8 Nm.
Courtesy of JAGUAR CARS, INC.
Install the new seals.

Courtesy of JAGUAR CARS, INC.

CAUTION: Make sure all suitable safety precautions are taken to protect the TCM and main control valve body electrical connector pins against electrostatic discharge.

Install the sealing tube.

Courtesy of JAGUAR CARS, INC.
Reposition the TCM and main control valve body electrical connector retaining ring.
1. Connect the electrical connector.
2. Reposition the electrical connector retaining ring.
Courtesy of JAGUAR CARS, INC.
Reposition the locking device.
Install the fluid pan, gasket and filter. See Fluid Pan, Gasket and Filter .