Pedestrian Protection Module - Removal and Installation: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 Jaguar XKR, 2009 Jaguar XK8, 2008 Jaguar XKR, 2008 Jaguar XK8, and 2007 Jaguar XKR. However, it is still accessible from the selected car via links, so may be relevant.
- Install the pedestrian protection module.
- Connect the electrical connector.
- Tighten the new Torx bolts to 10 Nm (7 lb.ft).
- Install the front LH fender splash shield. Refer to Fender Splash Shield article.
- Using WDS, configure a new module.