Headlamp Alignment Control Module: Service and Repair

Headlamp Leveling Module

Removal
1. Remove the RH side footwell heater duct.
- Remove the 2 Torx screws.
- Release the lamp holder.







2. Carefully release the carpet for access.

CAUTION: Make sure the wiring harness and electrical connectors are not damaged during the carpet release.

3. Remove the subwoofer cover.
- Remove the 4 bolts.







4. Remove the headlamp leveling module.
- Remove the 2 bolts.
- Disconnect the electrical connector.







Installation
1. Install the headlamp leveling module.
- Connect the electrical connector.
- Tighten the bolts to 3 Nm (2.2 lb.ft).
2. Install the subwoofer cover.
- Tighten the bolts to 10 Nm (7 lb.ft).
3. Install the carpet.

CAUTION: Make sure the carpet is correctly installed and that no foul-condition exists when the accelerator pedal is depressed.

4. Install the RH side footwell heater duct.
- Install the Torx screws.
- Install the lamp holder.