DTC Index

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2012 Jaguar XFR, 2012 Jaguar XF, 2011 Jaguar XFR, 2011 Jaguar XF, and 2010 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00

NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component.

NOTE: Generic scan tools may not read the codes listed, or may read only five digit codes. Match the five digits from the scan tool to the first five digits of the seven digit code listed to identify the fault (the last two digits give extra information read by the manufacturer-approved diagnostic system).

NOTE: When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to three decimal places and with a current calibration certificate. When testing resistance, always take the resistance of the DMM leads into account.

NOTE: Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.

NOTE: If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.

DTC	Description	Possible Cause	Action
B105A01	Cabin Temperature Sensor Fan	Aspirator motor diagnostic circuit - short to ground, open circuit Aspirator fan component failure	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check aspirator motor diagnostic circuit for short to ground, open circuit
B108100	Left Temperature Damper Motor	Left hand blend stepper motor internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B108149	Left Temperature Damper Motor	Left hand blend stepper motor internal electronic failure	Suspect the left hand blend stepper motor. Check and install a new stepper motor as required, refer to the new module/component installation note at the top of the DTC Index
B108200	Right Temperature Damper Motor	Right hand blend stepper motor internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B108249	Right Temperature Damper Motor	Right hand blend stepper motor internal electronic failure	Suspect the right hand blend stepper motor. Check and install a new stepper motor as required, refer to the new module/component installation note at the top of the DTC Index
B108301	Recirculation Damper Motor	RECIRC servo motor circuits - short to ground, power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check RECIRC servo motor circuit for short to ground, power, open circuit
B108500	Defroster Damper Motor	Defrost stepper motor internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B108549	Defroster Damper Motor	Defrost stepper motor internal electronic failure	Suspect the defrost stepper motor. Check and install a new stepper motor as required, refer to the new module/component installation note at the top of the DTC Index
B108600	Air Distribution Damper Motor	Panel/foot stepper motor internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B108649	Air Distribution Damper Motor	Panel/foot stepper motor internal electronic failure	Suspect the panel/foot stepper motor. Check and install a new stepper motor as required, refer to the new module/component installation note at the top of the DTC Index
B108788	LIN Bus "A"	LIN Bus power #1 circuit - open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check LIN Bus power #1 circuit for open circuit
B108888	LIN Bus "B"	LIN Bus power #2 circuit - open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check LIN Bus power #2 circuit for open circuit
B11ED68	Electric Heater Control Module	Event information. Electric heater - invalid communication message	Clear DTC. With engine coolant temperature low, set climate temperature to high and re-test. If DTC remains in isolation suspect the PTC heater, check and install a new heater as required, refer to the new module/component installation note at the top of the DTC Index. If additional LIN related DTCs are logged refer to the Actions for these DTCs
B11ED87	Electric Heater Control Module	Electric heater - missing communication message	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system
B11ED96	Electric Heater Control Module	Component internal failure	Suspect the PTC heater, check and install a new heater as required, refer to the new module/component installation note at the top of the DTC Index
B11ED98	Electric Heater Control Module	Component or system over temperature	Clear DTC. With engine coolant temperature low, set climate temperature to high and re-test. If DTC remains suspect the PTC heater, check and install a new heater as required, refer to the new module/component installation note at the top of the DTC Index
B11EE01	A/C Compressor	Air conditioning compressor clutch solenoid circuits - short to ground, power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check air conditioning compressor clutch solenoid circuits for short to ground, power, open circuit
B11F011	Air Intake Damper Position Sensor	RECIRC servo motor air intake feedback and 5 volt supply circuits - short to ground	Refer to the electrical circuit diagrams and check RECIRC servo motor air intake feedback and 5 volt supply circuits for short to ground
B11F015	Air Intake Damper Position Sensor	RECIRC servo motor air intake feedback and ground circuits - short to power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check RECIRC servo motor air intake feedback and ground circuits for short to power, open circuit
B11F800	Left Outer Vent	Left outer IP vent actuator internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system.
B11F849	Left Outer Vent	Left outer IP vent actuator internal electronic failure	Suspect the left outer IP vent actuator. Check and install a new actuator as required, refer to the new module/component installation note at the top of the DTC Index
B11F900	Left Inner Vent	Left inner IP vent actuator internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system.
B11F949	Left Inner Vent	Left inner IP vent actuator internal electronic failure	Suspect the left inner IP vent actuator. Check and install a new actuator as required, refer to the new module/component installation note at the top of the DTC Index
B11FA00	Right Inner Vent	Right inner IP vent actuator internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system.
B11FA49	Right Inner Vent	Right inner IP vent actuator internal electronic failure	Suspect the right inner IP vent actuator. Check and install a new actuator as required, refer to the new module/component installation note at the top of the DTC Index
B11FB00	Right Outer Vent	Right outer IP vent actuator internal or external fault	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system.
B11FB49	Right Outer Vent	Right outer IP vent actuator internal electronic failure	Suspect the right outer IP vent actuator. Check and install a new actuator as required, refer to the new module/component installation note at the top of the DTC Index
B11FF84	A/C Refrigerant Pressure	Signal below allowable range. A/C System Refrigerant Pressure too low	This DTC can be logged by the system due to low ambient temperature soak (below 3°C) reducing the pressure in the refrigerant gas system. If the cabin temperature logged along with the DTC at the time is below 10°C this could indicate low temperature. If the air conditioning performance is satisfactory and the in-cabin temperature is below 10°C then it is likely that the system contains a suitable amount of gas and the DTC is being recorded as an effect of the low ambient temperature. If this is not the case carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check air conditioning pressure sensor circuits for short, open circuit. Check for correct charge weight
B11FF85	A/C Refrigerant Pressure	Signal above allowable range. A/C System Refrigerant pressure too high	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check air conditioning pressure sensor circuits for short, open circuit
B1A5911	Sensor 5 Volt Supply	Air conditioning pressure sensor or RECIRC servo motor 5 volt supply circuits - short to ground	Refer to the electrical circuit diagrams and check air conditioning pressure sensor and RECIRC servo motor 5 volt supply circuits for short to ground
B1A5913	Sensor 5 Volt Supply	Air conditioning pressure sensor 5 volt supply circuits - open circuit	Refer to the electrical circuit diagrams and check air conditioning pressure sensor 5 volt supply circuit for open circuit
B1A6011	Pollution Sensor - Hydrocarbon	Pollution sensor hydrocarbon input circuit - short to ground	Refer to the electrical circuit diagrams and check pollution sensor hydrocarbon input circuit for short to ground
B1A6111	Cabin Temperature Sensor	In car temperature sensor circuit - short to ground	Refer to the electrical circuit diagrams and check In car temperature sensor circuit for short to ground
B1A6115	Cabin Temperature Sensor	In car temperature sensor circuit - short to power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check In car temperature sensor circuit for short to power, open circuit
B1A6311	Right Solar Sensor	Right sun load sensor signal circuit - short to ground	Refer to the electrical circuit diagrams and check right sun load sensor signal circuit for short to ground
B1A6411	Left Solar Sensor	Left sun load sensor signal circuit - short to ground	Refer to the electrical circuit diagrams and check left sun load sensor signal circuit for short to ground
B1A6713	Sensor Ground	Sensor ground circuits - open circuit	Refer to the electrical circuit diagrams and check sensor ground circuits for open circuit
B1A6901	Humidity Sensor	Humidity sensor PWM input circuit - short to ground, power, open circuit Sensor component failure	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check humidity sensor PWM input circuit for short to ground, power, open circuit. Check and install a new sensor as required
B1B6211	Pollution Sensor - NOx	Pollution sensor NOx input circuit - short to ground	Refer to the electrical circuit diagrams and check pollution sensor NOx input circuit for short to ground
B1B7111	Evaporator Temperature Sensor	Evaporator temperature sensor signal circuit - short to ground	Refer to the electrical circuit diagrams and check evaporator temperature sensor signal circuit for short to ground
B1B7115	Evaporator Temperature Sensor	Evaporator temperature sensor signal circuit - short to power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check evaporator temperature sensor signal circuit for short to power, open circuit
B1B7211	LIN Bus #1 Power Supply Circuit	Stepper motor circuit LIN Bus #1 power supply - short to ground	Refer to the electrical circuit diagrams and check stepper motor circuit LIN Bus #1 power supply for short to ground
C1B1413	Sensor Supply Voltage A	RECIRC servo motor 5 volt supply circuit - open circuit	Refer to the electrical circuit diagrams and check RECIRC servo motor 5 volt supply circuit for open circuit
C1B1513	Sensor Supply Voltage B	RECIRC servo motor and EVAP sensor ground circuits - open circuit	Refer to the electrical circuit diagrams and check RECIRC servo motor and EVAP sensor ground circuits for open circuit
P053011	A/C Refrigerant Pressure Sensor A Circuit	Air conditioning pressure sensor signal circuit - short to ground	Refer to the electrical circuit diagrams and check air conditioning pressure sensor signal circuit for short to ground
P053015	A/C Refrigerant Pressure Sensor A Circuit	Air conditioning pressure sensor signal circuit - short to power, open circuit	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system. Refer to the electrical circuit diagrams and check air conditioning pressure sensor signal circuit for short to power, open circuit
U001088	Medium Speed CAN Communication Bus	Bus off	Carry out any pinpoint tests associated with this DTC using the manufacturer approved diagnostic system.
U030000	Internal Control Module Software Incompatibility	Invalid configuration message is received	Re-configure the RJB using the manufacturer approved diagnostic system. Clear the DTC and retest. If the DTC is still logged suspect the climate control module, refer to the new module/component installation note at the top of the DTC Index
U1A1449	CAN Initialization Failure	Internal electronic failure	Suspect the climate control module, check and install a new module as required, refer to the new module/component installation note at the top of the DTC Index
U300055	Control Module	Incorrect car configuration data received	Re-configure the RJB using the manufacturer approved diagnostic system. Clear DTC and re-test. If the DTC remains suspect the climate control module. Check and install a new module as required, refer to the new module/component installation note at the top of the DTC Index
U300087	Control Module	Missing message	Re-configure the RJB using the manufacturer approved diagnostic system. Check climate control module for DTCs and refer to the DTC Index. Carry out CAN network integrity tests using the manufacturer approved diagnostic system. If DTC remains suspect the climate control module. Check and install a new module as required, refer to the new module/component installation note at the top of the DTC Index
U300281	Vehicle Identification Number	Vehicle/component mis-match. Corrupt VIN data being transmitted, module previously installed to other vehicle	Check and install original/new module as required, refer to the new module/component installation note at the top of the DTC Index