LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jaguar >> 2014 >> XK Base, 2D Convertible >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Supplemental Restraint System -- XK/X150 >> Supplemental Restraint System >> Rollover Protection Unit >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

  1. Install the roll over protection unit.
    • Tighten the Torx bolts to 25 Nm (18 lb.ft).
    • Connect the electrical connector.
  2. Install the rear seat backrest retaining bracket.
    • Tighten the nuts and bolts to 10 Nm (7 lb.ft).
  3. Install the rear seat backrest trim panel.
    • Tighten the bolts to 10 Nm (7 lb.ft).
    • Install the clips.
  4. Install the rear seat backrest.

    For additional information, refer to: Rear Seat Backrest (Removal and Installation).

  5. Connect the battery ground cable and install the cover.

    For additional information, refer to: BATTERY, MOUNTING AND CABLES -- XK/X150 (Specifications).

  6. Connect WDS to the vehicle and configure a new module.
scientia non olet · About LEMON Manuals