Cruise Control System Test 3

TEST 3 - LAMP NO. 2 WILL NOT LIGHT: IGNITION IN ON, CRUISE SWITCH ON

Conditions

Specification

If Incorrect, Perform:

Terminal B ⁽¹⁾

Battery voltage

Replace cruise switch

Terminal 5 ⁽²⁾

Battery voltage

Repair open from cruise switch

Across 2 & 3 ⁽²⁾

15-50 ohms

Go to next step

Across A & B ⁽³⁾

15-50 ohms

⁽⁴⁾ Go to next step

Across A & B ⁽⁵⁾

⁽⁶⁾

Replace speed sensor

⁽¹⁾	Cruise switch connector.

⁽²⁾	Module connector terminal(s).

⁽³⁾	Speed sensor terminal(s).

⁽⁴⁾	If okay, repair open to module.

⁽⁵⁾	Speed sensor terminal(s), with rear wheel spinning.

⁽⁶⁾	At 30 MPH, 0.9v AC. and voltage should increase 0.1v AC per each 10 MPH.