Fuel Injectors

The fuel injectors are controlled electronically by the engine controller. Because each injector is connected to 12 volts, the injector is energized when connected to ground through the engine controller. The engine controller also controls the amount of time the injector is energized (pulse width). Pulse width is based on various inputs and is calculated by the engine controller. The fuel injectors are sequentially energized, by firing order, by the engine controller.

With injector connected to a pressurized fuel supply, a fine mist will spray from the injector nozzle into the intake manifold. The injector uses an electromagnet and spring pressure to open or close the fuel metering plunger. When connected to battery voltage, the coil of wire in the injector becomes an electromagnet. The magnetic field generated will overcome spring pressure and raise the plunger off its seat. When the injector circuit is opened by the engine controller, the magnetic field collapses and spring pressure forces the plunger against its seat.

Whenever an injector is opened, it will always spray a consistent amount of fuel for a given amount of pressure. Because pressure drop across the injector is fixed and the fuel flow rate constant, the only control variable is the amount of time injector is open. By controlling the time the injector is open (pulse width), the engine controller can decrease pulse width for engine idle or it can increase pulse width at wide open throttle.