LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1993 >> Cherokee Country, 2D Utility, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Test 3A >> "G" Switch Not Processable
April 5, 2026: LEMON Manuals is launched! Read the announcement.

"G" Switch Not Processable

  1. Ensure "G" switch sensor assembly is properly installed. If not properly installed, repair as necessary and perform VERIFICATION TEST VER-1A. If "G" switch is properly installed, turn ignition off. Disconnect and inspect CAB 55-pin connector and "G" switch sensor 3-pin connector. Repair connectors as necessary.
  2. Turn ignition on. With DRB-II in voltmeter mode, probe "G" switch connector terminals individually. If voltage is present, repair short to voltage in that "G" switch circuit. Perform VERIFICATION TEST VER-1A. If voltage is not present at any terminals, go to next step.
  3. Turn ignition off. With DRB-II in ohmmeter mode, probe "G" switch connector terminals individually with remaining lead connected to chassis ground. If resistance at any terminal is less than 5 ohms, repair short to ground in that circuit. Perform VERIFICATION TEST VER-1A.
  4. If resistance at each terminal is more than 5 ohms, connect jumper wire between ground and "G" switch terminals No. 1-3. Check for continuity to ground on CAB terminals No. 25, 26 and 43. If continuity to ground does not exist, repair open in that circuit. Perform VERIFICATION TEST VER-1A. If continuity to ground exists, replace CAB. Perform VERIFICATION TEST VER-1A.
scientia non olet · About LEMON Manuals