Test 18B - Repairing Disarm Sense Circuit From Remote Keyless Entry Module
NOTE:
For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For appropriate wiring diagram, see appropriate chassis wiring diagram in the WIRING DIAGRAMS
article.
- Determine if all courtesy, dome and cargo lights are functioning properly. Repair interior lights that are not functioning properly.
- Disconnect Remote Keyless Entry (RKE) module. See Figure in TEST 3A. Using DRB-II, check courtesy light control circuit voltage at terminal "C" (Violet/Orange wire) of RKE module connector. If voltage is less than 10 volts, repair open courtesy light control circuit (Violet/Orange wire). Perform TEST VER-1 . If voltage is more than 10 volts, replace RKE module. Perform TEST VER-1 .