Power Mirror Motor
Remove door trim panel. See POWER MIRROR ASSEMBLY under REMOVAL & INSTALLATION. Unplug power mirror harness connector. Connect jumper wire to ground. Connect second jumper wire to 12-volt power source. Connect each jumper wire as indicated in POWER MIRROR MOTOR TEST . If mirror does not function as specified, replace mirror assembly.
POWER MIRROR MOTOR TEST
| 12 Volts | Ground | Mirror Reaction | |
|---|---|---|---|
| Left Mirror | |||
| Pin "A" | Pin "C" | Down | |
| Pin "B" | Pin "C" | Left | |
| Pin "C" | Pin "A" | Up | |
| Pin "C" | Pin "B" | Right | |
| Right Mirror | |||
| Pin "A" | Pin "C" | Down | |
| Pin "B" | Pin "C" | Left | |
| Pin "C" | Pin "A" | Up | |
| Pin "C" | Pin "B" | Right | |