Speed Control Switches
WARNING: This page is about a different car, the 1996 Chrysler Sebring. However, it is still accessible from the selected car via links, so may be relevant.
Access speed control switches. Disconnect both speed control switch 2-pin connectors. Using an ohmmeter, check both speed control switches. If either speed control switch does not test as specified, replace defective switch. See appropriate SPEED CONTROL SWITCH RESISTANCE table.
SPEED CONTROL SWITCH RESISTANCE
| Switch Position | Resistance (Ohms) | |
|---|---|---|
| ON/OFF Switch | ||
| None Depressed | No Continuity | |
| OFF | 0.0-0.5 | |
| ON | 15,245-15,555 | |
| RESUME/SET/CANCEL Switch | ||
| None Depressed | No Continuity | |
| SET | 2910-2970 | |
| RESUME | 6580-6720 | |
| CANCEL | 900-920 | |