Anti-Theft System Test 3A - Enabling Anti-Theft System
NOTE:
Perform ANTI-THEFT SYSTEM TEST 1A
before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION
and WIRING DIAGRAM. See ANTI-THEFT SYSTEM article. Perform TEST VER-2A
after each repair.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Turn ignition off. Using scan tool, select BODY COMPUTER INPUT/OUTPUT. Observe door key cylinder status. Insert key in left front door lock cylinder. Turn key to unlock position. If scan tool does not display DOOR KEY CYL: CLOSED, go to ANTI-THEFT SYSTEM TEST 7A. If scan tool displays DOOR KEY CYL: CLOSED, go to next step.
- Using scan tool, select MISCELLANEOUS ENABLE VTSS - YES. Select MODULE DISPLAY. If module ID displays ZJ BODY BCM W/VTSS, return to ANTI-THEFT SYSTEM TEST 1A . If module ID does not display ZJ BODY BCM W/VTSS, replace body control module.