LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1996 >> Grand Cherokee Orvis >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Computer >> Testing >> Vehicle Communications Tests >> Test 5A - No Response From Driver Door Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 5A - No Response From Driver Door Module

  1. Remove junction block circuit breaker No. 2 (30-amp). Junction block is behind right kick panel. Using scan tool in voltmeter mode, measure voltage on battery supply voltage side of circuit breaker socket. If voltage is 10 volts or less, repair open battery supply circuit. If voltage is more than 10 volts, go to next step.
  2. Replace circuit beaker with known good component. If circuit breaker cycles on and off, repair component side of circuit breaker socket for short to ground. If circuit breaker does not cycle on and off, go to next step.
  3. Determine is scan tool still displays NO RESPONSE from driver door module. If scan tool does not display NO RESPONSE, inspect component side circuit of circuit breaker No. 4 for intermittent short circuit. If scan tool displays NO RESPONSE, go to next step.
  4. Disconnect driver door module 12-pin connector. Using scan tool in voltmeter mode, measure voltage on driver door module connector, terminal No. 12 (Tan wire). If voltage is 10 volts or less, repair open Tan wire. If voltage is more than 10 volts, go to next step.
  5. Using scan tool in ohmmeter mode, measure resistance on terminal No. 7 (Black wire). If resistance is 5 ohms or greater, repair open Black wire. If resistance is less than 5 ohms, go to next step.
  6. Connect jumper between driver door module connector, terminal No. 8 (Violet/Brown wire) and ground. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open Violet/Brown wire. If scan tool displays BUS SHORT TO GROUND, go to next step.
  7. Connect jumper between driver door module connector, terminal No. 9 (White/Black wire) and ground. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open White/Black wire. If scan tool displays BUS SHORT TO GROUND, replace driver door module.
NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION  and WIRING DIAGRAM  . After each repair, perform VERIFICATION TEST VER-1.
CAUTION: Always turn ignition off prior to disconnecting any module connector.
scientia non olet · About LEMON Manuals