Power Mirror Motor Test
- Remove door trim panel. See FRONT DOOR TRIM PANEL under REMOVAL & INSTALLATION. Disconnect power mirror 6-pin connector. Connect jumper wire to ground.
- Connect second jumper wire to 12-volt power source. Connect each jumper wire as indicated in POWER MIRROR MOTOR TEST . See Fig 1 . If mirror does not function as specified, replace power mirror.
POWER MIRROR MOTOR TEST
| Connect 12 Volts To Terminal No. | Connect Ground To Terminal No. | Mirror Reaction |
|---|---|---|
| 1 | 4 | Up |
| 4 | 1 | Down |
| 2 | 3 | Left |
| 3 | 2 | Right |
| 5 | 6 | Heater |