Information Center Test 4C - Rear Lamp Failure Message
NOTE:
Perform INFORMATION CENTER TEST 4A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Refer to DOOR LOCKS - POWER & KEYLESS ENTRY SYSTEM
article. After each repair, perform TEST VER-1A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
Lamp outage module will cause information center to display a REAR LAMP FAILURE message if an incorrect bulb is installed. Inspect all light bulbs for correct application. See vehicle owner's manual for correct bulb number. Replace bulb(s) as needed. If all bulbs are correct, replace lamp outage module.