Instrument Cluster Test 9A - All Warning Lights Not Operating Properly

NOTE: Perform INSTRUMENT CLUSTER TEST 1A before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION . For wiring diagrams, refer to WIRING DIAGRAMS . Refer to INSTRUMENT PANEL article. After each repair, perform TEST VER-1A .

CAUTION: Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.

Using scan tool, select MIC CLUSTER menu. Run ACTUATOR TEST. If all bulbs do not illuminate, replace circuit board. If all bulbs illuminate, cluster is currently operating correctly.