Power Mirror Test 5C - Repairing Open Memory Mirror Circuit
NOTE:
Perform POWER MIRROR TEST 5A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Refer to MIRRORS - POWER
article. After each repair, perform TEST VER-1A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Disconnect driver's or passenger's power mirror connector from door module. Connect a jumper wire between terminals "C" and "D" on door module power mirror. See Figure under POWER DOOR LOCK TEST 2B. If scan tool displays MIRROR VERT: OPEN, replace appropriate door module. If scan tool displays MIRROR VERT: SHORT, go to next step.
- Connect a jumper wire between terminals "D" and "E" on door module power mirror. If scan tool displays MIRROR VERT: OPEN, replace appropriate door module. If scan tool displays MIRROR VERT: SHORT, replace appropriate mirror.