VTSS Test 3A - Enabling VTSS
NOTE:
Perform VTSS TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Refer to ANTI-THEFT SYSTEM
article. After each repair, perform TEST VER-2A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
- Turn ignition off. Using scan tool, select BODY COMPUTER INPUT/OUTPUT. Observe door key cylinder status. Insert key in left front door lock cylinder. Turn key to unlock position. If scan tool does not display DOOR KEY CYL: CLOSED, go to VTSS TEST 7A . If scan tool displays DOOR KEY CYL: CLOSED, go to next step.
- Using scan tool, select MISCELLANEOUS ENABLE VTSS - YES. Select MODULE DISPLAY. If module ID displays ZJ BODY BCM W/VTSS, return to VTSS TEST 1A . If module ID does not display ZJ BODY BCM W/VTSS, replace body control module.