LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1999 >> Cherokee Limited, 2.5 P >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Verification Tests >> Test VER-5A >> Final Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Final Procedure

  1. Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If any DTCs have not been diagnosed, return to appropriate test(s) listed under SELF-DIAGNOSTIC TESTS. See DTC MESSAGES & CODES table and finish diagnosing remaining DTCs as necessary. If all DTCs have been diagnosed and repaired, go to next step.
  2. Connect scan tool to Data Link Connector (DLC) if not previously done. Ensure fuel tank is at least 1/4 full. Ensure A/C is off. Go to next step.
  3. Proper way to ensure DTC is repaired is to allow Powertrain Control Module (PCM) to run monitor. Monitor operation may be observed on scan tool. All specified enabling conditions for specified DTC must be met before PCM will operate monitor. Go to next step.
  4. Using scan tool, monitor pretest enabling conditions until all conditions have been met. Once all enabling conditions are met, observe appropriate monitor for DTC on scan tool. If repaired DTC has reset or is See n in monitor while on road test, repair is not complete. Check for related Technical Service Bulletins (TSBs) and return to appropriate test listed under SELF-DIAGNOSTIC TESTS. See DTC MESSAGES & CODES table. If no DTCs return, test is complete. Go to step 6).
  5. If another DTC exists, return to appropriate test(s) listed under SELF-DIAGNOSTIC TESTS. See DTC MESSAGES & CODES table. If no DTCs return, test is complete. Go to next step.
  6. Turn ignition on, with engine off. Using scan tool, erase DTCs. Turn ignition off. Disconnect scan tool. Test is complete.
scientia non olet · About LEMON Manuals