LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Cherokee Classic, 2D Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Tests >> Speed Control Resume/ACCEL Switch >> Cherokee
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Speed Control Resume/ACCEL Switch: Cherokee

  1. Turn ignition on. Turn Speed Control (S/C) ON/OFF switch on. While observing scan tool, press RESUME/ACCEL switch several times. If scan tool displays RESUME/ACCEL switch PRESSED and RELEASED, test is compete. If scan tool does not display PRESSED and RELEASED, go to next step.
  2. Turn ignition off. Disconnect S/C RESUME/ACCEL switch. See SPEED CONTROL SWITCHES  under REMOVAL & INSTALLATION. Inspect connector. Clean or repair as necessary. Connect a jumper wire between S/C RESUME/ACCEL switch connector terminal No. 2 (Red/Light Green wire) and ground. Turn ignition on. Using scan tool, read S/C switch voltage. If voltage is less than one volt, replace RESUME/ACCEL switch. Perform TEST VER-4A  under VERIFICATION TESTS. If voltage is one volt or more, go to next step.
  3. Turn ignition off. Using an ohmmeter, check resistance between RESUME/ACCEL switch harness connector terminal No. 1 (Brown/Yellow wire) and ground. If resistance is 5 ohms or more, repair open ground circuit. Perform TEST VER-4A  under VERIFICATION TESTS. If resistance is less than 5 ohms, repair open S/C switch signal circuit. Perform TEST VER-4A  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals