LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Grand Cherokee Laredo, 4.0 S, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Memory Seat >> Front Riser Out Of Range Low
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Riser Out Of Range Low

  1. Ensure Memory Seat Module (MSM) is connected before proceeding. Disconnect driver's power seat front riser sensor Black 3-pin connector. Turn ignition on. Using DVOM, measure voltage between driver's power seat front riser sensor connector terminal "C" (Brown/White wire) and ground. If voltage is greater than 4.5 volts, go to next step. If voltage is less than 4.5 volts, go to step  6.
  2. Turn ignition off. Connect a fused jumper between driver's power seat front riser sensor connector terminals "B" (Brown wire) and "C" (Brown/White wire). Using scan tool, select BODY, MEMORY SEAT then SENSORS. Turn ignition on. Read FRONT RISER POSITION SENSOR voltage. If voltage is less than 4.5 volts, go to next step. If voltage is greater than 4.5 volts, replace seat track assembly. See appropriate POWER SEATS article. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  3. Disconnect MSM connector C1. MSM is located under driver's seat. Using DVOM, measure resistance between MSM connector C1 terminal No. 17 (Brown wire) and ground. See Figure. If resistance is greater than 1000 ohms, go to next step. If resistance is less than 1000 ohms, repair short to ground in Brown wire. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  4. Using DVOM, measure resistance of Brown wire between MSM connector C1 terminal No. 17 and driver's power seat front riser sensor connector terminal "B". If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open in Brown wire. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  5. Replace MSM. See MEMORY HEATED SEAT MODULE, HEATED SEAT MODULE, MEMORY SEAT MODULE  under REMOVAL & INSTALLATION. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  6. Turn ignition off. Disconnect MSM connector C1. See Figure. Using DVOM, measure resistance between driver's power seat front riser sensor connector terminal "C" (Brown/White wire) and ground. If resistance is greater than 1000 ohms, go to next step. If resistance is less than 1000 ohms, repair short to ground in Brown/White wire between MSM and driver's power seat front riser sensor. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  7. Using DVOM, measure resistance of Brown/White wire between driver's power seat front riser sensor connector terminal "C" and MSM connector C1 terminal No. 18. See Figure. If resistance is less than 5 ohms, go to next step. If resistance is greater than 5 ohms, repair open in Brown/White wire between MSM and driver's power seat front riser sensor. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
  8. Replace MSM. See MEMORY HEATED SEAT MODULE, HEATED SEAT MODULE, MEMORY SEAT MODULE  under REMOVAL & INSTALLATION. Perform MEMORY/HEATED SEATS VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals