Starter Relay: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.

Power Distribution Center:

2. Unlatch and open the cover on the Power Distribution Center (PDC).
3. See the fuse and relay layout label affixed to the underside of the PDC cover for starter relay identification and location.
4. Remove the starter relay from the PDC.

INSTALLATION
1. See the fuse and relay layout label affixed to the underside of the PDC cover for the proper starter relay location.
2. Position the starter relay in the proper receptacle in the PDC.
3. Align the starter relay terminals with the terminal cavities in the PDC receptacle.
4. Push down firmly on the starter relay until the terminals are fully seated in the terminal cavities in the PDC receptacle.
5. Close and latch the PDC cover.
6. Reconnect the battery negative cable.