LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2001 >> Grand Cherokee Laredo, 4.0 S, AWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Communications >> Bus +/- Signals Open From Passenger's Door Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Bus +/- Signals Open From Passenger's Door Module

NOTE: Ensure PCI bus communication between other modules exists before proceeding. If PCI bus module communication does not exist between other modules, go to appropriate system test. See SYMPTOM IDENTIFICATION  table under RETRIEVING & CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM.
  1. Turn ignition off. Disconnect PDM C1 connector. PDM is part of passenger's power window and door lock switch assembly. Turn ignition on. Using DVOM, measure voltage between PDM C1 connector terminal No. 1 (Tan/Black wire) and ground. See Figure . If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, repair open or short to ground in Tan/Black wire between PDM and junction block. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  2. Turn ignition off. Using DVOM, measure resistance between PDM C1 connector terminal No. 4 (Black wire) and ground. If resistance is less than 10 ohms, go to next step. If resistance is greater than 10 ohms, repair open in Black wire between PDM and ground. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  3. Use Scope Input Cable (CH7058), Cable-To-Probe Adapter (CH7062) and Red and Black test probes. Connect scope input cable to channel one connector on scan tool. Attach Red and Black test probes and cable-to-probe adapter to scope input cable. Select scan tool STANDALONE function. Select LAB SCOPE. Select LIVE. Select 12 VOLT SQUARE WAVE. Press F2 for scope display. Press F2 and use down arrow to select voltage range to 20 volts. Press F2 after selecting 20 volts. Connect Black test probe lead to ground and Red test probe lead to PDM C1 connector terminal No. 9 (Yellow/Violet wire). Turn ignition on. Observe voltage readings on scan tool. If reading pulses from zero to approximately 7.5 volts, go to next step. If reading is steady at zero volts, repair PCI bus circuit (Yellow/Violet wire) between PDM and diagnostic junction port. See DATA LINK CONNECTORS article in WIRING DIAGRAMS. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  4. Replace PDM. See appropriate POWER WINDOWS article. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals