LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2001 >> Grand Cherokee Laredo, 4.7 N, RWD >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Instrument Cluster >> High Beam Indicator Not Operating Properly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

High Beam Indicator Not Operating Properly

  1. Turn high beam headlights on. If high beam headlights operate properly, go to next step. If high beam headlights do not operate properly, perform appropriate test under EXTERIOR LIGHTING  . Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
  2. Press and hold TRIP/RESET button on instrument panel. Turn ignition from off to on. Mechanical Instrument Cluster (MIC) self-test will start. If HIGH BEAM indicator light illuminates for about 4 seconds and then goes out, test is complete. If HIGH BEAM indicator light does not illuminate for about 4 seconds and then go out, go to next step.
  3. Remove and inspect HIGH BEAM indicator bulb. Replace as needed. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS. If bulb is okay, replace instrument cluster printed circuit board. See appropriate INSTRUMENT PANELS article. Perform BODY VERIFICATION TEST  under VERIFICATION TESTS.
scientia non olet · About LEMON Manuals