Controller Anti-Lock Brake: Installation

WARNING: This page is about a different car, the 2004 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the CAB is being replaced with a new CAB is must be reprogrammed with the use of a DRB III.

Install CAB to the HCU. See Figure .
Install mounting bolts. Tighten to 2 N.m (16 in. lbs.).
Install the pump electrical connector to the CAB. See Figure .
Install the wiring harness connector to the CAB and push down on the release to secure the connector.
Install negative battery cable to the battery.