Wide Open Throttle Mode
WARNING: This page is about a different car, the 2004 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
This is an Open Loop mode. During wide open throttle operation, the PCM receives the following inputs.
- Battery Voltage
- Crankshaft Position Sensor
- Engine Coolant Temperature Sensor
- Intake Manifold Air Temperature Sensor
- Manifold Absolute Pressure (MAP) Sensor
- Throttle Position Sensor (TPS)
- Camshaft Position Sensor Signal (In The Distributor)
During wide open throttle conditions, the following occurs:
- Voltage is applied to the fuel injectors with the ASD relay via the PCM. The PCM will then control the injection sequence and injector pulse width by turning the ground circuit to each individual injector on and off. The PCM ignores the oxygen sensor input signal and provides a predetermined amount of additional fuel. This is done by adjusting injector pulse width.
- The PCM adjusts ignition timing by turning the ground path to the coil on and off.
- The Up-shift Indicator Lamp is operated (manual transmission only).