Remote Keyless Entry (RKE) Transmitter
WARNING: This page is about a different car, the 2002 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For more information, see TSB REMOTE KEYLESS ENTRY (RKE) PROGRAMMING PROCEDURES
.
New RKE transmitters can be programed using the DRBIII® scan tool. See BODY CONTROL MODULES - LIBERTY article. The DRBIII® scan tool can provide confirmation that the PCI data bus is functional, and that all of the electronic modules are sending and receiving the proper messages on the PCI data bus.
The following procedure can be used as long as one functioning transmitter is available:
- Using the original transmitter, press the UNLOCK button for 4-10 seconds.
- Without releasing the UNLOCK button, press the PANIC button (within the 4-10 second interval).
- Release both buttons.
- Press LOCK and UNLOCK simultaneously on the original transmitter.
- Release both buttons.
- Press any button on the ORIGINAL transmitter. A chime tone from the instrument cluster will confirm the programming of the ORIGINAL transmitter.
- On NEW transmitter, press LOCK and UNLOCK simultaneously.
- Release both buttons.
- Press any button on the NEW transmitter. A chime tone from the instrument cluster will confirm the programming of the NEW transmitter.
- Up to 4 transmitters can be programed for one vehicle.