Integrated Power Module: Installation

WARNING: This page is about a different car, the 2005 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing IPM

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: If replacing the Integrated Power Module (IPM) (1) with a new assembly it will be necessary to transfer the circuit protection devices as well as the Front Control Module to the new IPM.

Position the IPM into the vehicle.
Connect the two Front Control Module (FCM) connectors (5).
Connect the two IPM connectors (4).
Position the IPM over the three bracket tabs (2) and apply downward pressure until the retaining clips snap into place securely.

Fig 2: Removing/Installing Battery Positive Cable
Courtesy of DAIMLERCHRYSLER CORP.
Install the battery positive cable (3) from the IPM B+ terminal stud.
Install the nut (2) from the IPM B+ terminal stud.
Close the IPM cover ensuring the locking tabs snap firmly in place.
Connect the battery negative cable.