Module-Fuel Pump: Removal

WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: FUEL PUMP MODULE (TOP) - DIESEL

Courtesy of DAIMLERCHRYSLER CORP.

Drain and remove fuel tank. (Refer to FUEL SYSTEM/FUEL DELIVERY - STANDARD PROCEDURE)
Note rotational position of pump module before attempting removal. An indexing arrow (4) is located on top of module for this purpose.
Disconnect pigtail harness connector (2) at pump module (7).
Disconnect fittings (3) and (6) from pump module (Refer to FUEL SYSTEM/FUEL DELIVERY/QUICK CONNECT FITTING - STANDARD PROCEDURE) .

Fig 2: Fuel Pump Module Location
Courtesy of DAIMLERCHRYSLER CORP.
Position Lockring Remover/Installer 9340 (3) into notches on outside edge of lockring (5).
Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
Rotate breaker bar counter-clockwise to remove lockring.
Remove lockring. The module will spring up slightly when lockring is removed.
Remove module from fuel tank. Be careful not to bend float arm while removing.