Sensor-Accelerator Pedal Position: Removal
WARNING: This page is about a different car, the 2006 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of DAIMLERCHRYSLER CORP.
| 1 - HARNESS CONNECTOR |
| 2 - FASTENERS |
| 3 - ACCELERATOR PEDAL ASSEMBLY |
- Disconnect the negative battery cable.
- Remove the drivers side lower dash board close out panel.
- Disconnect the APP sensor electrical connector (1). See Fig 1.
- Remove the accelerator pedal assembly fasteners (2) and the accelerator pedal assembly (3). See Fig 1.