Module-Fuel Pump: Removal

WARNING: This page is about a different car, the 2007 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: FUEL PUMP MODULE (TOP) - DIESEL

Courtesy of CHRYSLER LLC

Drain and remove fuel tank. See STANDARD PROCEDURE .
Note rotational position of pump module before attempting removal. An indexing arrow (4) is located on top of module for this purpose.
Disconnect pigtail harness connector (2) at pump module (7).
Disconnect fittings (3) and (6) from pump module. See STANDARD PROCEDURE .

Fig 2: Fuel Pump Module Location
Courtesy of CHRYSLER LLC
Position Lock Ring Remover/Installer 9340 (3) into notches on outside edge of lock ring (5).
Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
Rotate breaker bar counter-clockwise to remove lock ring.
Remove lock ring. The module will spring up slightly when lock ring is removed.
Remove module from fuel tank. Be careful not to bend float arm while removing.